When trying to port coreboot (previously LinuxBIOS) to a new mainboard you're often confronted with a big problem: the BIOS/ROM chip on the respective motherboard is soldered onto the board (i.e., not in a socket).
This means that you cannot easily (hot-)swap the chip during development or for recovery purposes. So you basically have exactly one try to flash the ROM chip with a fully working/booting coreboot image. If that goes wrong your board is bricked.
This makes it pretty much impossible to develop a coreboot port for such boards (and soldered-on ROM chips are becoming more and more common, unfortunately).
However, I've recently tried to replace the soldered-on (PLCC) ROM chip on one of my boards with a socket. What sounds pretty scary at first, especially given that I have almost non-existant soldering skills, turned out to be really not that hard. Also, it can be done with relatively cheap and readily available equipment.
I have written a short HOWTO for desoldering chips and soldering on sockets in the coreboot wiki, and also finished a video showing most of the process, which I hope will be helpful for others:
$ youtube-dl -t 'http://www.youtube.com/watch?v=30x4oxyczH4'
I also tried to upload the video to Vimeo, but first they told me to install the Flash 10 abomination (and there's no way I will do that). After browsing the help/forum pages a bit I found a traditional, non-flash upload form, but that then tells me that I cannot upload Ogg Theora videos. WTF?
The Ogg Theora video support feature request has been open for more that a year. Until that issue is fixed I'll just use other video services, thanks...